Products

Wooden warping sticks. Set of 16.

Enhance your weaving experience with this ergonomic bench, specially designed for Louët looms: Jane, David, Spring, and Magic Dobby. Made from soli...

This Louet bench is suitable for the Octado loom. The bench, made of lacquered beech, is height adjustable from 23.5” to 27.5”. This bench is shipp...

This Louët bench is height-adjustable for Delta and Megado looms.The bench, in varnished beech, is adjustable from 23.5 in. to 27.5 in.This bench i...

Include footman, connector and footman to wheel connector with ring. Doesn't fit the S90 nor the Victoria (S95)

The high speed bobbin for all our Irish tension (bobbin driven) spinning wheels, except the S70, S71 and S90. The slot in the shaft allows you to e...

This bobbin will fit with older wheels whose original flyer was a bulky flyer. The Bulky bobbin fits well with current Bulky bobbin and Art yarn fl...

Standard bobbin for the following Louet Scotch tension (flyer driven) Spinning wheels: S10C with Scotch Tension Mother of all S11 Julia S95 Victor...

This is the standard lacquered bobbin for all Louët Irish Tension wheels. This bobbin can be used for older wheels too - S10, S51, S20, S60, S70, S...

Bobbin for Louët bobbin rack.

The warp tension regulator (often call a tension box) is used with the Sectional Warp Beam and is adjustable to fit any Louet floor loom back beam.

Footman bolt assembly S10 pre S10C, S7X series, S15, S51(S0131)

Lisa frame loom is available in 4 sizes. The smallest one is perfect for an introduction to the World of Weaving and comes with a flat shuttl...

This extension kit contains all the hardware needed to add an extra shaft to the Erica 30 craft. This looms can have a maximum of 4 shafts.

The Louët pirns are specially designed for use with the Louët flying shuttle system on David III, Spring II, Octado and Megado looms. These pirns e...

The spool rack is essential for sectional warping and can be used for different other studio tasks. The Louet bobbin rack can hold up to thirty-two...

Louët hand cards are made from European basswood.They are lightweight. Their backs are slightly curved and their handles are ergonomically designed...

Louët hand cards are made from European basswood.They are lightweight. Their backs are slightly curved and their handles are ergonomically designed...

Louët hand cards are made from European basswood.They are lightweight. Their backs are slightly curved and their handles are ergonomically designed...

With its near 4 inch width, the Louët Junior carder is particularly suitable for carding fleeces for spinning or for small felting projects.  ...

The Louët Standard carder is a workhorse. With a width of 7 1/2 inches, fleeces of up to approx. 80 grams can be carded. Mixing colors and fibers i...

This accessory to the Louet warp tension regulator is used to measure the warp. The tension regulator also called tension box is used with sectiona...

Footman to treadle connector for all wheels except the S90. This is the part on the bottom of the footman.

Footman to treadle connector for the S95/S96 only. This is the part on the bottom of the footman.